wiki

OpenIPC Wiki

Table of Content

Troubleshooting: Network does not work

Some IP-cameras require additional parameters set to make the network interface work.

For recent firmware

Use extras boot variable. In Linux console run this

fw_setenv extras 'hieth.phyaddru=0 hieth.phyaddrd=1' && reboot

If the above settings did not work, try this instead

fw_setenv extras 'hieth.phyaddru=1 hieth.phyaddrd=0' && reboot

If the above settings did not work, try this instead

fw_setenv extras 'hieth.mdioifu=0 hieth.mdioifd=0' && reboot

If the above settings did not work, try this instead

fw_setenv extras 'hieth.mdioifu=1 hieth.mdioifd=1' && reboot

If nothing of the above worked for you, seek help on our Telegram channel.

For older firmware

Set phyaddru and phyaddrd variables from U-Boot console:

setenv phyaddru 0; setenv phyaddrd 1; saveenv; reset

If the above settings did not work, try this instead

setenv phyaddru 1; setenv phyaddrd 0; saveenv; reset

If the above settings did not work, try this instead

setenv phyaddru 0; setenv phyaddrd 0; saveenv; reset

If the above settings did not work, try this instead

setenv phyaddru 1; setenv phyaddrd 1; saveenv; reset

If nothing of the above worked for you, seek help on our Telegram channel.